Removing a Stripped Screw

Have you ever been faced with the problem of trying to repair something, and when you go to screw or unscrew a screw find out that you can't? Looking closely when this happens, chances are you are going to notice that the screw is stripped. Man I hate when this happens, it means that the screwdriver I am using is not going to work at all, no matter what I do. At least, that is what it used to mean, since with this handy dandy how to list I, and now you, can replace that dang screw.

Materials Needed

• Screwdrivers—as many sizes as you can get (both flathead and Philips if possible)
• Metal saw or cut-off tool such as a Dremel
• Standard drill bit
• Safety glasses
• Screw extractor, or left handed drill bit
• Standard drill bit

Once you have collected all of these materials, you are ready to begin.

1. The first thing that you need to do is that you apply a Philips screwdriver that is larger in size than what is usually used. Push down really hard, using an angle, and try to slowly remove the screw. In the event that the stripping worsens, you need to stop immediately.
2. If that doesn't work, then you can try removing the screw with a large flathead screwdriver. If the slits are centered on the stripped head, then use the largest flathead screwdriver that is going to fit the slot. Using pressure on the screw, try to turn the screw counter-clockwise. This might be able to get the screw out, while if it doesn't move, or if it strips the screw more than it is already, you can go ahead and try the next step.
3. Use the Dremel tool, or the metal saw, to create a slit in the in the screw. When you are doing this you pretty much want to make sure that you wear the safety glasses so that you do not get any metal slivers or dust thrown into your eyes. After you have created that notch into the screw, then retry the last step.
4. Use your drill, and create a hole that is smaller than the head of the screw. This hole should be approximately 1/3 the size of the head, and into the screw itself about 1/4 of an inch into the body itself. Insert a very small Philips screwdriver into the hole and attempt to remove the screw.
5. Use either the screw extractor or your left-handed drill bit if you have one. You need to push down on the stripped screw head, you need to slowly try to remove the screw, be sure that you are careful not to push too hard, or the screw may break.
6. If any of these previous methods fail, then as a last resort you can always drill the screw out. In order to do this you just need to have a drill bit that is either the same size or slightly smaller than the shank of the screw. If you don't know the size of the screw, simply take another one of the screws and compare it to a drill bit in order to find the proper fit. If you are trying to remove any screws from electronic equipment, then you need to be careful since the pieces of the screws may fall.